Dose anyone know the torque specs on doing a top end and what's the best way to get the clips back on the piston
torque spec
- Thread starter blastblast
- Start date
and for the clips there tricky . i used a small punch and held one end in and pushed the punch around kinda shimin the clip in. its sounds confusin this way but it aint hard
I use needle nose pliers for the clips. i grab one end and get the other end started . twist it in dont bend it in.
Hopefully you're using new clips. Me thinks you ought to check this out http://www.blasterforum.com/engine-13/how-install-cylinder-31635/
Yeah new everything is going on it thinks for the video link and all the help with the clips i think that is goin to be the hardest part of the hole thing
Stuff a rag around crank/rod just in case you drop a clip. I mostly use my fingers and small straight screwdriver on them
