stroker crank

[blasterdemon7]

Can you run a 3 mil stroker crank with a factory top end.

The answer is yes. Just make sure you install the spacer under the jug.

 

[cmblaster]

Thank you for.getting back to the original post. I have the shim installed and am putting it back together now.

 

[blasterdemon7]

You shouldn't have a problem if its installed correctly. Make sure you do a leak down test.

 

[cmblaster]

I do not have a leak tester. Does anybody know where i can acquire one

 

[best]

I do not have a leak tester. Does anybody know where i can acquire one

Local hardware store for fittings and a low pressure gage.
Old tire valve stem, cut the rubber off and fit it in a hose.
Rubber expanding frost plug bung or a metal plate and rubber sheet to seal the exhaust.
Round plumbing plug to seal the intake where the carb fits on.
Cheap and easy to make, some members used to sell them on here.
Do a search and find past threads outlining how to make your own.
You need it.

Steve

 

[gizzy2014]

Local hardware store for fittings and a low pressure gage.
Old tire valve stem, cut the rubber off and fit it in a hose.
Rubber expanding frost plug bung or a metal plate and rubber sheet to seal the exhaust.
Round plumbing plug to seal the intake where the carb fits on.
Cheap and easy to make, some members used to sell them on here.
Do a search and find past threads outlining how to make your own.
You need it.

Steve

AKA make one for urself