Rebuild carb still bogging

Discussion in 'Engine' started by Mark Lionelli, Jun 8, 2021 at 4:50 PM.

  1. Mark Lionelli

    Mark Lionelli New Member

    Joined:
    Jun 29, 2020
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    17
    Gender:
    Male
    Hey everyone
    Can anyone help?
    I have a 2000 Blaster
    Just had a carb rebuilt
    Fresh fuel and starts right up but Boggs down when I throttle up...
    Did check the plug and air filter.
    Thanks
     
  2. Awk08

    Awk08 Administrator Staff Member Technician

    Joined:
    Jan 30, 2009
    Messages:
    24,387
    Likes Received:
    2,268
    Trophy Points:
    175
    Occupation:
    Electrician/Contractor
    Location:
    Pa.
    Get a new the plug, you cannot see the oil up inside the electrode that causes 2 stroke plugs to foul ... NGK B8ES
    unhook the TORS brain under the hood .... 3 wire plug
    check your reeds, broken or cracked reeds will give the same symptoms, a new gasket and a light coat of copper rtv sealant or yamabond on both sides of it is recommended when reinstalling the reed cage, let it cure overnight, then a leakdown test should be done also
     
    Slydog likes this.
  3. Slydog

    Slydog Active Member Technician

    Joined:
    Nov 3, 2019
    Messages:
    2,106
    Likes Received:
    367
    Trophy Points:
    119
    Gender:
    Male
    Occupation:
    Diesel mech
    Location:
    Florida
    And be careful to not over tighten the reed cage bolts if cage is removed to check reeds. Over tightening causes air leaks.
    Good luck,
     

Share This Page