Oil Leak 96 blaster

[intillect]

Air can't be sucked in at that spot, however if you had the blockoff plate off it might not have sealed. Is that where the oil leaked out of though ???????????

It didn't leak there but i took that plate off to drain some of the fluid and to investigate it and reinstalled it. It didn't have a gasket and i didn't have one so i didn't put one on. Could that be causing the air leak

 

[intillect]

well that would suck tranny fluid in the cylinder

would that cause a hanging idle. What else would that do besides suck oil into the cylinder.

 

[Hillbilly_Proud]

u need a gasket for it... it could possibly cause the hanging idle.?.

 

[intillect]

well that is good new because that and the oil draining out were the only two things that changed when the hanging idle started.

 

[intillect]

So I cleaned the carb and adjusted the throttle and other little things today and I made a video

this is just a video of the hanging idle. It drives fine and it seems like the idle only hangs in neutral I tried to make a leak tester but was unsuccessful. Besides the throttle cable and air leaks what else could cause the hanging idle.