Just changed the swing arm bearings, so old and worn out that the bearing was squished almost flush with the diameter of the hole. It was pretty bad but an overall smooth install
I got the carb parts and a few other little things i needed thanks to a fellow blaster brother on here,
but one of the engine bolts i received isn't working its the small one for the very bottom. The frame has the nut welded to it from the factory but the threads seemed to be stripped could i ream the hole out a bit and just get another nut and bolt to hold it in as long as its not over torqued so i won't crack the case?
And i picked this up today, is this oil as great as it says? All the guys at my local motorsports place highly recommended thisView attachment 21729
If the threads are stripped I really don't see another option. I would use a nut and lock washer with loctite, or a lock nut. And try and utilize the same size bolt if possible.Cool, thank you guys. I'm down here in south Florida it doesn't get very cold here ever so I think I'll be good.
And about that bottom engine mounting bolt, you think it would be ok to drill the hole bigger to put a bolt through and tighten a nut onto it?
If the threads are stripped I really don't see another option. I would use a nut and lock washer with loctite, or a lock nut. And try and utilize the same size bolt if possible.
I gave you a clutch cable. I thought it had one on there.Got the engine in and everything all together but i realized I'm missing the clutch cable holder that goes to the cylinder base nut right next to the actuator, in need of that and a chain slider. Its part number 13. if anyone has one ill buy it off you, trying to not spend 26 dollars for such a tiny piece off of parts warehouse
View attachment 21901
Naw i didn't get a clutch cable from you, just went out and rechecked, i already had one. I have a lot of brake lines from you though lol...Do you have the little clutch cable holder at all? I got the engine in last night finally and pretty much got it ready to start heat cycles, just need exhaust coupler which imma go get some heater hose from auto parts store. But i still need the clutch cable holder.I gave you a clutch cable. I thought it had one on there.
Let me check later. If I have it still it should be there. I also have a slider and exhaust coupler.Naw i didn't get a clutch cable from you, just went out and rechecked, i already had one. I have a lot of brake lines from you though lol...Do you have the little clutch cable holder at all? I got the engine in last night finally and pretty much got it ready to start heat cycles, just need exhaust coupler which imma go get some heater hose from auto parts store. But i still need the clutch cable holder.
Ive had to buy almost every nut and bolt on this bike. I resurrected a scrap metal pile
Yea for sure!For sure if you don't its cool ill just order it, If i can get it here before the weekend ill try to load it up and come up there if you're cool with that?