I just installed a DMC Alien exhaust, K&N air filter w/outerware prefilter, and a VForce 3 reed cage. I also purchased a Dynojet kit, choosing the #360 jet (per Dynojet instructions for stage 2 setup) and replaced the needle w/Dynojet needle & clip (in #3 pos.). DMC suggests running a #260 jet with clip set in #5 pos. Who should I listen too? Anybody running about the same setup have any ideas? I live in Iowa, ride at alt. of 500-1000 (roughly)feet depending on where I ride in state, with temps and humidity all over the board. any suggestions would be much appreciated.
