jetting problems, idle hangs

[juiceboxxx26]

my blaster seems to idle higha and hang reguardless of how rich i make it.
Im in Staten island NY whcih is about sea level,
I have a 360 Main Jet
needle in second from the bottom and pilot jet is 32.5 i believe, (Stock)
Mix is 32:1 It just seems that it.
air filter with no air box lid. stock exhaust

 

[UniRacing]

WAY WAY to rich,

Stock jetting is 230

With no mods accept air box lid removed,you should be about 250

 

[4cfed]

holy crap batman!! 36o main?!?!?!? your drownding that motor and loosing sooooooo much power!! like stated should be at a 250 or so...


as for the hanging idle... check for air leaks around the reed cage/carb boot, base gasket and head gasket ( base and head most of the time you wil see oil seeping) for checkin by the reed cage/ carb boot, and the carb hat, spray with carb cleaner and see if the motor reacts to it.. you WILL know if you find a leak when spraying... if that checks out ok, make sure your throttle cable is lubed, and opens and closes freely.... i lube my cables 2-3 times a year

 

[sr5bidder]

+1 on the air leak another area to check for leaks is the crank seal behind the stator/flywheel.

 

[juiceboxxx26]

ok so im going to put the stock msin jet back in, will i have to move the needle up to lean it out now that im going to do thiat???

 

[speedracinshift]

u should jus have it right in the middle with the needle. and like about a 250 main like they others are say n. run it check the plug andif need be then fine tune with needle setting if only a little bit off on topend.