DT200R engine in my Blaster

[BaBarossa]

Some Pic from my Blaster, the engine doen't fit without work! The suspension points are not the same, the swingarm must get cut of and the exhaust needs some work, too.
I hope that next week the Blaster runs again

 

[Stryder917]

looks good, bet it'll run like hell when you're done -- post results when you're running!

good luck

 

[MXmaineiac67]

props for being creative but,


I dont see what the point is?? I mean its a 200cc engine like the blaster.

 

[blasterman312]

I like it.....and its better cus its liquid cooled?

 

[BaBarossa]

It's a watercooled engine with 66x57mm (195ccm), 35HP on stock. I drilled it up to 68mm and built in the vitos +3 crank, FMF Fatty with Q, Woessner special racing piston(225$) and 28 Mikuni flatside carb. I think it blows me 40HP+ :-D .

 

[fastLANE]

sweet

 

[Dan151]

damn thats crazy. Nice work FastLane. im quite jealous

 

[dirtbmxer7]

i wish i could get my hands on one of thos

 

[crusty4365]

i wouldnt bother with changing the lower engine mounts i would just bolt the cylinder on the blasters lower engine

 

[BaBarossa]

When I bolt the DT cylinder on the Blasters crankcase, I've got no intake!

 

[crusty4365]

then you must have a wr200 engine... this is a dt200 engine- notice the intake is on the cylinder like a blaster cylinder.

wr200 engines have the intake on the crank case like a yz125... so u def have a wr200 engine cuz dt200 engines intakes are on the cylinder

 

[BaBarossa]

I'm sure, it's a DT200R engine! I bought the whole motorbike B-) - with documents!