DMC Exhaust

[Pj Uptmor]

I am try to install a the DMC Exhaust and I can't get the silencer to line up with any hole at the rear grab mount. Does it mount to right side if u are setting on it . Correct. Me if I am wrong.

I appreciate any suggestions

 

[Pj Uptmor]

One more question on this Exhaust. When I am tightening the exhaust flange look I an bending it toward the motor. Is there a spacer that goes on the studs tighten it down to.

 

[joeak47]

One more question on this Exhaust. When I am tightening the exhaust flange look I an bending it toward the motor. Is there a spacer that goes on the studs tighten it down to.

If I were you I would STOP and read the instructions on installation.
You shouldn't be bending ANYTHING to make it fit. Seriously?

 

[Pj Uptmor]

If I were you I would STOP and read the instructions on installation.
You shouldn't be bending ANYTHING to make it fit. Seriously?

SERIOUSLY. I would if I had the instructions. I will can dmc tomorrow to get the the instructions. I just trying to finish this build before spring break so my son can at little Sahara.

 

[joeak47]

Seriously?

Lets get serious about this so you don't bend anything...

Its in the right hand column on the home page.

Strait from the DMC web site \/ \/ \/ \/ \/ \/ Instructions below.


https://dmc-on-line.com/PDF/Blaster-Alien.pdf

S e r i o u s l y...

 

[Pj Uptmor]

Tighten the exhaust flange nuts down you can bend the flange If you over torque the nuts. I was try to c if I was miss parts that all seriously. I will call dmc

 

[Pj Uptmor]

Thank you I didn't see that yesterday when I was looking for the instructions.

 

[joeak47]

No problem. Your welcome.