Cylinder

Prime

New Member
Jul 11, 2011
1,056
15
0
Batavia, NY
I was thinking about keeping this for myself, but figured someone else here would have better use for a clean slate than I do. So, here is a stock bore, unported cylinder. Had the cylinder mic'd last week, it is a true, usable 66.00mm. (when I say usable I don't mean OK, it is a good bore.) Also had it honed to put some crosshatches in. $110 + shipping takes it.





 
NONPORTED!!!!!!!!!!!!!!!!!??????????????????? hahahahha bump for a good guy

Yea nonported dude this is a steal he can drill 2 dinky little holes in it and sy
ay its ported and get x2 as much dude this is a buy someone jump all over this I thought I bought a stock bore but turned out it waz 40 over bump for great guy
 
Yea nonported dude this is a steal he can drill 2 dinky little holes in it and sy
ay its ported and get x2 as much dude this is a buy someone jump all over this I thought I bought a stock bore but turned out it waz 40 over bump for great guy

Thanks speedy, I should have taken a picture of it at the machine shop, right on the money at 66.00 mm
 
Another week or two I'm probably going to put it up on eBay. I'd like to sell it here to avoid dealing with eBay but it's gotta go.


already bought too many goodies this week, maybe next week