Crank case leak

[Jmurph]

Replaced the gaskets and have some bolt holes that are stripped out. Top left and bottom left what is the best way to get these to seal, new to the blaster/ 2stroke scene.TIA

 

[Slydog]

Replaced the gaskets and have some bolt holes that are stripped out. Top left and bottom left what is the best way to get these to seal, new to the blaster/ 2stroke scene.TIA

I'm assuming clutch cover?
If gasket was replaced.
The tourqe on these bolts is low. 88 inch lbs
Or something close to that. You would have to look that up.
Over tightening will strip them out.
Are long and short bolts in the right places?(don't remember if there is different lengths on that cover)
Might need to helicoil it.
Somtimes you can install a little longer bolt.
Remove striped bolt and stick a pick or something small in hole and measure depth. With you finger .hold it next. Bolt to see the difference. If bolt is too short install longer bolt and don't over tighten.
Good luck . let us know how you do