Can someone just tell me whcih holes are for what and if i need them attached to anything, Thanks!
Carb Holes
- Thread starter MasonBraaps
- Start date
Brass nipple on right side is for oil injection. Cast nipple is bowl vent. Large hole is cast for drilling idle screw.
Left side is same except oil injection.
Left side is same except oil injection.
You're only missing the vent lines,
and DO NOT run it again until you block off the unused oil injection line with an 1/8" vacuum cap,
or it will fry, if it already isn't worn bad, depending on how long that injection nipple was left open as a huge air leak ?
and DO NOT run it again until you block off the unused oil injection line with an 1/8" vacuum cap,
or it will fry, if it already isn't worn bad, depending on how long that injection nipple was left open as a huge air leak ?
there shoulda/woulda/coulda been 2 small brass eyelets on the back 2 carb bowl screws for the vent lines to run thru and hold them.
just run them down with the drain line and ty-rap them all together, as long as the vents run below the carb bowl you'll be fine
Yea I have the brass eyelets on an old junk carb
there shoulda/woulda/coulda been 2 small brass eyelets on the back 2 carb bowl screws for the vent lines to run thru and hold them.
just run them down with the drain line and ty-rap them all together, as long as the vents run below the carb bowl you'll be fine
