blaster wont rev and takes forever to start

[StillRuns2001]

Hi all, I've got a 2001 Yamaha blaster that's completely stock.

I've removed the tors on it by unplugging all the wires and it ran great since then but just recently i cleaned the carb to fix a bogging issue at top end but when I slapped the carb back on it started bogging all the time except on the top end. I just decided to buy a new carb and it does the same thing that the old stock oem carb did.

I have 115 PSI of compression, barely a month old dual stage Boysen power reeds with a small gap between the petals and the reed cage but its always ran great and started first kick no matter what until I cleaned the carb.

any help would be greatly appreciated, thanks

 

[Awk08]

Use your original stock carb, ZERO new carbs from anywhere contain the jetting required for a blaster.

Have you checked/set the float height ?
https://www.blasterforum.com/threads/float-heights-and-how-to-adjust-them.50565/

cleaned the jets properly ?
https://www.blasterforum.com/threads/how-to-clean-your-carbureutor.254/

adjust airscrew ?
https://www.blasterforum.com/threads/adjusting-your-airscrew-pilot-jet.51060/