Blaster is not running right after new topend.

ford88mustang

New Member
Sep 27, 2009
258
0
0
It wont idle and is has no lower power at all. And now I am having trouble getting it started. I have been messing with it for the past two days, I am about to give up.
 
Last edited:
the air screw is the one next to the fuel inlet. you should screw it all the way in, and then back out 1.5 turns. no, it doesn't matter what way the reeds go in, but they DO need to be completely sealed when sitting there, absolutely NO gaps. if they aren't sealed, just take them off and flip them over
 
the air screw is the one next to the fuel inlet. you should screw it all the way in, and then back out 1.5 turns. no, it doesn't matter what way the reeds go in, but they DO need to be completely sealed when sitting there, absolutely NO gaps. if they aren't sealed, just take them off and flip them over

Thanks a lot dude. I'm going to try that now. Can you tell what the screw on the other side of the carb does ?