240 blaster jet help

[tsufilmz]

first off i live in Michigan i have a fresh 240 blaster with a port and polish. i am running a kein 35mm carb i had it running with a 160 main needle in the center slot and off hand i don't know the piolt jet. it ran i was braking it in it seemed rich. now i cant get get it to fire noting i have spark and it has back pressure. when i would get on it it would pop and miss then it sputterd out after i had run a tank of gas through it. did i fry the rings idk what happend help me.

sorry for bad spelling.

help please

Jeff

 

[FLOTEK]

sounds like a fouled plug ,whats the plug look like ???????

 

[Kennedy_Power]

Where in Michigan do you live...
Done hundreds of big bore blasters.....
I can help you out, even dyno tune it for you

 

[blaster biotch]

or broke the key on the flywheel. not torqued properly. if it spits and pops this could very well be the case

 

[tsufilmz]

i got it thanks tightend up the flywheel put a new plug and droped the jet to a 155 main. it fired first kick and runs GREAT

Thanks

 

[Kennedy_Power]

Good job Jeff, let me know is you want to dyno the bike!