i have a stock blaster and want to take off the airbox.i also have a uni filter installed..currently running a 230 jet..what jet size should i go to next?i live in upstate ny if that makes any difference
02 blaster jet question
- Thread starter beaten blaster
- Start date
I would say start at #260 and plug chop to confirm.
Plug chop.
Warm up motor to operating temp.
Fit new B8ES plug, ride through the gears and hold WOT in 5th or 6th gear for 10 seconds, or as long as you can safely.
Switch off the motor and pull in the clutch, roll to a stop.
Take the plug out and replace the old one for the ride home.
Carefully cut the threaded end off the plug to expose the insulator.
There should be a smoke ring of a cardboard or biscuit colour around the insulator.
If it is non existant or a very light colour, you are lean and require a larger main jet.
If it is a lot darker you are rich and may go down a size in main.
I prefer to run a little on the darker side, I may loose a little power but it is worth it for the peace of mind that I won't need a rebuild so soon.
http://www.blasterforum.com/do-yourself-20/how-plug-chop-38674/
http://www.blasterforum.com/engine-13/plug-chop-how-vid-48226/
This is a good to go plug.
This one is a little rich, but I would run it, I like to be on the safe side.
Plug chop.
Warm up motor to operating temp.
Fit new B8ES plug, ride through the gears and hold WOT in 5th or 6th gear for 10 seconds, or as long as you can safely.
Switch off the motor and pull in the clutch, roll to a stop.
Take the plug out and replace the old one for the ride home.
Carefully cut the threaded end off the plug to expose the insulator.
There should be a smoke ring of a cardboard or biscuit colour around the insulator.
If it is non existant or a very light colour, you are lean and require a larger main jet.
If it is a lot darker you are rich and may go down a size in main.
I prefer to run a little on the darker side, I may loose a little power but it is worth it for the peace of mind that I won't need a rebuild so soon.
http://www.blasterforum.com/do-yourself-20/how-plug-chop-38674/
http://www.blasterforum.com/engine-13/plug-chop-how-vid-48226/
This is a good to go plug.
This one is a little rich, but I would run it, I like to be on the safe side.
hey guy i have a quick question i have a 02 blaster that has an fmf full system boysen stage 2 reed pedals reed spacer k&n air filter cfm air-box with he stock carb and a performance spark plug what jetting sizes should i use i am near Newark in northern jersey its almost an a half hour away from newark thanks muchh
Similar threads
