Search results

The mods i have are. FMF Powercore 2, Boysen Power Reeds, K&n filter that is completely clean.

My blaster will not rev very high. It has alot of bottom end power but has no top end. it almost sounds like there is a rev limiter kicking in? The compression is 150psi and the carb is clean. I dont know if it is an electrical issue or mechanical. Any and all advice would be great...

Ok so, i looked into the crank case and there was no oil in the case. after i sealed up the boot and cage, i filled the case with oil and then tried starting it. when it did start it smoked me out of my garage. I am asuming that this means it is the right side crank shaft seal? is it the oil...

Thanks for the help. I started pulling apart the motor, but before i got to far i saw that there was no gasket or sealant between the carb boot and the reed cage. looks like there was one at some point and time, but the guy that had this blaster before me was kinda of a hack. Would this cause...

Thanks for your help. Could bad reeds cause this issue? i cant tell for sure but it looks like the bottom right reed isnt closing. thanks

i have 93 blaster. it takes a little bit of effort to get it started. Once it is started it runs really rough and if you ride it, then pull in the clutch or put it in nuetral it stays at a really high rpm. I thought the throttle was sticking, but then i checked and that was fine. It did it...