Search results

I got my top end bored out got a new Wiseco piston, gaskets and everything. I also got a 30mm OKO carb. It started up and ran good but would not idle which turned out to be missing a step in the TORS removal. Then I started it and let it idle for a few minutes and it reved up really high. I...

I just had my top end bored .002 and got a new piston and rings for the bigger size. I put everything back together and pushed the kick start with my hand as the manual says to do. It seems to be pretty tight but I could tell that the piston travelled up and down a few times. Is is normal for it...

I have a 2004 blaster and could not get it to start a while back. I ended up eliminating the TORS, cleaned the carb, and replaced the floats. Now I can get it to run, but it will not usually rev and if it does it cuts out and the engine dies. I was wondering if the needle position had anything...

I have a 2004 blaster that has been sitting for about 2 years. When I got it from a friend in 2006 it ran great but never did want to idle right. The jet needle has never been changed and I set the air pilot screw to 1.5 turns off of fully in (read it in a manual). I did move from SC to Texas...