Search results

Okay so I had a broken piston, got my cylinder checked out and honed, most of the damage was to the head, which was cut .030 to take out all the divits. After I got it back I put the new piston and rings in as the bearings and seals seemed fine. It started the second kick (first kick the...

I am going to part out my blaster if it doesn't sell soon. I have the whole thing on CL for 750 right now. Here is what it has: CPW30mm carb, F7 pipe, 400ex rear shock, LT 250r front shocks, 4 inch ext. swingarm, tusk clutch kit, K&N air filter, Banshee steering stem, oil system...

I have recently rebuilt my blaster with fresh paint, and many other things. One of the things that I did was to replace the rear bearings. Now there is a whine as I speed up. It was making heat...which turned out to be the sprocket hub on the seal. Has anyone ever had their rear end whining...

okay here is what I have: tie rods with ends in good shape two cdi's-12 shipped ea two key holders-10 shipped ea two pairs of pegs-20 shipped a pair two thumb throttle assemblies stock swingarm-50 shipped front shocks-20 shipped headlight and support-25 shipped cylinder in good shape...

Are you guys that are running 30mm carbs getting it into the stock boot from the airbox. It fits into the intake manifold fine. Also it has a 145 main in it now... would that be a decent starting point for my mods?

I checked K mart and the local home depot... just wondering where you guys have bought it.

I put a used set of LT 250R shocks on the blaster the other day for fun. The preload is all the way down but I still had to compress them slightly to get them on. When I sit on the bike they squat some. They did raise the front up slightly. They are slightly stiff but in my opinion are...

I am sure this has been done before... but I wanted to give people my review. First off I installed it by making the needle bearing inside the shock longer to fill the gap and then made spacers and packed everything very well with grease. The inside needle bearing tube is now thinner but we...

I bought a new clutch and it is soaking. Going to install tonight... I just have one question though. The steel plates have a "dimple" I was wondering if they can only go in one way or is there a pattern or something to the way they go in. any help is appreciated, Thanks.

Okay I know this is a blaster forum but I have a 92 lt250r that needs a rear shock and I know there are some people on here that are really knowlegeable with the swaps and all. I need to know if anyone knows of shocks that will swap in easily. I would like fronts too if somone knows. They...

I was just wondering for those of you that have either of these size carbs if you could post up the SOP results and if you thought it was worth it or not. This winter I am going to tear down my blaster and repaint the frame and cut off some of the useless tabs and clean everything up. I am...

okay... so my blaster recently had a reed fail. not sure if that was the cause of the problem or a result. it started missing under full throttle and then eventually wouldnt run. had some pinging sounded like detonation to me. so now i have put new reeds in and it is still running bad...