Ok guys. So ny clutch wasnt working so i pulled off the cover and the push road wont budge. i tried everything to get it out. then i took off the actuator and i could see the rod down the hole had like a big lip on the outside of it stopping it from popping out. Had anybody any eay if getting...
Ok so this is my first blaster and my last one. Problem after problem with it. I have never got it running right Nd even still woth a different engine it's still not running.
Ok so I bought a second hand engine a vitos 240 is has 135 140 compression. When i got the engine I put it in and it...
Ok so after putting my bike back together. I can't get the bloody breaks to bleed at all. I tried a vaccine tool to try and pull it through and also pushing it through. Also I tried the syringe and hose. The fluid won't go past the bleeding nipple no matter what I do. I can't understand this at...
Ok so after many problems with my vlaster I finally nearly have it right. It has around 143 psi. I got a second hand engine with a vitos 240. Put it in my own frame wires it all up and it started first kick left it ticking over for a few mins shut it off and I seen gas coming from the carb. Now...
Hi guys. I just rebuild my whole motor and I done a compression test before I run it in. It has a 100 psi. This is woth a fresh jug,piston,piston rings crank seals and bearing. Is this a normal reading for a freshly build motor
Hi I'm just after doing a full rebuild on my blaster. Just before I installed the flywheel I blew into the Intake port and I could feel air coming through the case by the crankshaft on the flywheel side. I don't think it's supposed to that is it ? What would cause it to do that. It got all new...
hi guys I need a bit of help with my blaster. I gotta new chain and sprockets but when I put it on I noticed there is no carrier for me to adjust my chain. My back axel is a wider durable axel. Anybody have any idea how I would adjust to chain to get the right amount of slack
Hi. My Yamaha blaster is down on power. It has no reeds new top end new carb new chain and sprockets new clutch cable and new accelerator cables . It's starts first kick all the time but have to keep it slightly rev until it gets warm or else it will shut off. Anyone have any ideas.
Hi. Just wondering what u guys think of my porting job. I have only removed so material and i have to polish it yet. My question is do u think u have ported it enough and any suggestions. And do u think there will be much power agin from this. I have fmf exhaust. 30mm carb and v force 3 reeds...
Hi. Just wondering what u guys think of my porting job. I have only removed so material and i have to polish it yet. My question is do u think u have ported it enough and any suggestions.
Hi. I live in ireland and want to get my ports ported and polished. Ken o conor wont seem to respond to me. I am just wondering is there anywhere in ireland that does this service?