Search results

Yes

On my stock stator I can spin it a little clockwise and counterclockwise. I have it all the way clockwise on stock. Should I go 3mm from that point?

Will advanceing the timing Will it hurt any thing? If I'm off .5mm either way?

I know it's crazy and what is it bad If you don't get it exactly 4? say like 3.5mm or 4.5mm?

I know it's crazy and what is it bad If you don't get it exactly 4? say like 3.5mm or 4.5mm?

Put the washer on aND runs like a damn champ 100x more power THANK YOU EVERYONE!!!

Nailed it on the head!!! Got a buddy with a spare carb took the washer and putting it all back now let yall know thanks!!

So rook carb off for the 5th time to inspect it and this happens.. The needle /main jet tube came out. Does this mean new carb? If so where can I get a decent one not Chinese?

Its been off twice I've sanded the metal down di it gets good contact

I was talking about ignition coil. and I took stator off and sanded all around to a bare metal. also can you time a stock stator or is it only one position untill you DreMel the holes

how can I check it?

I sanded the flywheel the key is not Sheard also what washer under main jet.

I put another coil on my bike that I took off a running blaster and CDI still bogs doesn't change a bit

I tried with the gas tank cap off didn't help.

Put in my buddy's coil and CDI box off his blaster that runs fine and didnt change problem. It starts up good when cold then 1-2 mins and bogs and dies. Put on a different stator that I had laying around but don't know its a good stator or not. 150psi compression, held 7 psi for over 10 mins in...

Could my timing be off? How do I check? Also how do I check to see if my coil is good?

Put a new plug in and runs and revs fine then all a sudden feels like you engage parking brake but way worse.definitely feels like a electrical problem

I'm losing my mind!! I did a leak down test held 7 psi for over 15 minutes. Took apart carb looked at pilot jet and it was clean and clear bumped jet size down from a 340 to a 320. Float level is at 21mm. Reeds brand new. Top end has 150 compression. So I started it up after leak down test ,let...