Search results

Ive been lookin around for some cheaper priced ball bearings to replace the worn out trans and crank bearings in the suzuki ts90 engine I'm building. I had purchased japenese made koyo ball bearings for the last blaster motor I rebuilt and they were NOT cheap, around 30 bucks a piece at the...

Im sick of the ugly a$$, heavy steel blaster kickstarter LOL, so I'm fabbin up an aluminum one. Using the original lower steel splines and shaft pivot for now. Lower portion of the alum. Kick assembly is 1" thick billet. And the upper kick pedal is 3/8" 6061 T-6 plate cut out with a plasma...

Deciding to try out somthin new. I'm sure its been done before, but I've never seen it on here. I took my DIY ported cylinder to the weld shop today, and built up some welds on the outsides near the rear of the transfer ports. My goal is to add enough aluminum on the sides to open up the boyesen...

Been practicing my a$$ off at my college welding shop LOL, so I figured I'd share some pics! Doin a 3g vert up weld, gtaw 10ga thick mild steel sheet If you're wordering why the bead is all colorful and shiny, its cause we ran out Of er70s2 rod so I jus used some 308L stainless...

Somebody better buy this quick before its gone! Ill bet that exhaust will give MAX HP! Hahahaha LOL Yamaha Blaster 200 Custom Pipe Exhaust Muffler YFS200 | eBay

66.00mm STD bore,Blaster Wiseco piston kit -make an offer or trade for blaster parts Complete stock front end off of 2001 blaster, a arms/ shocks/tie rods/spindles/brakes -make an offer or trade for blaster parts. Yfz450 front shocks- make an offer or trade for blaster parts...

Here's some good info from wiseco on how to check ring end gap.I:I Wiseco 2 Stroke Tech Tip – Piston Ring Gap Posted on October 11, 2012 by Charles Owens 2-Stroke Tech: Are you checking your ring end gap? Why is end gap important on my 2-stroke? Proper end gap assures that the ring can...

I came across some good crankshaft rebuild info on another website, and figured I'd share it with you guysI:I Rebuilding a pressed pin crankshaft.

About three months ago I "attemped" to port a spare cylinder with a harbor freight dremel kit LOL, i figured I'd post some pics. Let me know what you guys think. I got a little carried away on that top intake port LOL

Got this sick aftermarket front end from the same guy on Craigslist that i got my Shearer exhaust system for 25bucks. honestly. NO JOKE the whole setup was only 150bucks! I took that fool to the cleaners haha Not sure exactly how many inches of extension those A-arms are, but ill measure...

Got a shearer expansion chamber and silencer today for only 25 bucks! I'd upload some pics to show you guys..... but I don't know how haha , anyways the only bad thing is, the stainless tubing for the silencer is bent and the exhaust manifold is missing. I'm gonna try to fabricate a manifold...