Recent content by XxWRAITHxX

When i say push it i dont mean force it once everything is lined up it will go all the way down easily

There is an alignment pin inside the carb and a groove on the slide. Sometimes the needle wont line up to go into the emulsion tube just reach your finger in there and line the needle up with the hole then push it the rest of the way down and tighten the cap.

The pic above shows excess casting in exhaust port on one of those cheap cylinders VERY SKETCHY could catch a ring. Bought it as a spare because it was cheap bad idea

No problem man, with your mods your pilot jet should be good based upon other threads ive read on here.

A plug chop is done to determine how lean or rich your main jet is by reading the spark plug. Warm the bike up on the plug you currently have in. Then when warm put a new plug in. Get the bike up to full speed and hold it wide open for a quarter mile or so, hit the kill switch and hold the...

You may have to jet a little bigger than that. The air filter off the carb is most likely going to allow a lot more air than the stock airbox. More air = more fuel. Im not jetting expert so you might wait to see what other people post. If it was me i would start 320 _ 330 and plugchop down

Thanx helpful post man i would say 412 wouldnt have much trouble sizzlin some spit lol

Thanx i know i have some jetting issues. i put in a 350 main of an off brand jet and someone on here told me that the sizes and quality may vary from genuine mikuni. Also may have a bad left side crank seal cuz i took the stator cover off and found wat appeard to be 2 stroke oil behind it think...

Was wondering how hot the top end on a blaster is supposed to get. after about a half hour ride on mine it seemed quite hot. I had a pair of shorts on and it was starting to burn my legs i spit on the head and it sizzled is this normal? I probably sound like an idiot but this is my first air...

Is a 98 blaster supposed to have brake fluid reservoirs?

Does anyone know if the vitos jet kit contains genuine mikuni jets?

Ya thats what i meant lol it wont gain rpm it just bogs it does fine on the road though.

Wow did not know that would make much of a difference lol so where can i find that brand of oil and yes the kit i bought came with a little rubber cap for it.

K cool ill give that a try thanx