Recent content by VANCE

got any 350 raptor parts? i need a stator and stator covers, airbox and upper mount bracket for the engine.

looking for 04 raptor 350 parts right now. need stator and stator covers. upper engine mount brackets, airbox.......

i love you man, thanks alot.

will hubs off an 88 warrior fit an 03 blaster? i want the 4/115 pattern. i put them on and rode for awhile, i noticed one side would rock alittle on the axle, i just tightened it back down and haven't rode yet. i 've had to tighten the stock hubs after a few rides, they would start to rock too...

what year did this raptor first come out? will warrior plastics fit it? what other quads can i get parts from? i just picked this up for a 100 bucks. it had a yamaha 3 wheeler engine on it and the plastics are shot. i need to find complete headlights, airbox, rear disc and an engine. anyone on...

i haven't talked to you in awhile...hope all is well.. issue, tightening my axle nut, should my wheel move at all forward or backward? if it does then i should tighten it more, right. i just don't want to over tighten it.

i just done the carrier bearings and seals. if i tighten the castle nut down to where it won't move forward or backward i'm good right? i thought all wheels had alittle play in them..it bothers me cuz i'm thinking that if it moves the slightest its going to wear my spline down on the hub or axle.

thanks for the advice on the castle nut..so i'm assuming tighen it as much as possible then put my cotter pin in? the wheel will move forward and backward alittle, not side to side.

how tight should i tighten my castle nut on my blaster? i don't want to over tighten it. is it normal for a little play to be there? my wheel will move some, hub to axle play.

how tight should i tighten my blaster axle nuts?

what about the collar for the disc? the offset for the sprocket and disc collar is all the same?

thanks man..when i think of the sprocket and disc it throws me off. are the hubs the same , w/ the collar for the disc and offset for the sprocket.

if i swap my stock blaster hubs out for a set of banchee hubs do i have to change anything else? like, disk, sprocket, ect, ect.

i just put new pads on, rode it a few times, tonight one of the pads sheared off,the outside one. i noticed when i put them one i couldn't get a good pressure. no oil leaks of any kind either.

i just put new pads on, rode it a few times, tonight one of the pads sheared off,the outside one. i noticed when i put them one i couldn't get a good pressure. no oil leaks of any kind either.