Recent content by UniRacing
-
-
Hanging idle,opinions?
I just put a new top end with all new gaskets,everything is torqued to spec,tors is still on the bike but it doesnt seem to be the cable or slide hanging. -
question before axle purchase
New bearings. same size nuts.- UniRacing
- Post #2
- Forum: General Support
-
-
Hanging idle,opinions?
Ok i just gotta fine thoes parts to make this. -
Hanging idle,opinions?
I would like to do an air leak test,i ned to build th tester,can i buy evrything at lowes? or auto zone maybe? -
Hanging idle,opinions?
Sorry guys but it hangs when i hit the gas and it hangs at around 2000 rms but if i let the clutch out a little it goes back down to normal and it runs fine,my motor shouldnt have any leaks its all oem gaskets torqued to spec,carb is supr clean -
-
-
Smoking really bad, oil dripping out of the exhaust :(
DRain your crank of all the oil that sucked in there before you put the new seal in. -
neeed HELP!!!!!!! 1993 yamaha blaster
Sounds like you over filled the oil. -
Got a good deal last week!
we have a xtp 650 max aswell,i like it better than the 800 -
350 warrior
sounds like a intake boot,the manifold that bolts to the engine often crack or split -
Got a good deal last week!
Hers is the outlander 800 with hmf and fuel stabilizer.. I just ordered a radiator relocate kit and I'm gunna snorkel it, I like the power but I hate how big and heavy it is!! -