Recent content by Stevo87

thats the exact diagram i used to do the float adjustment. i will check today for leaks. maybe give the head bolts a quarter turn tighter also.

alright messed with the floats and that seems to be the issue. the quad use to run good before i did a top end but now after i adjusted the float. one time the entire carb inside was soaked and the quad kept dying out on me after maybe 1-2 minutes of idling. i played with the floats again...

i was playing with the quad today and i didn't have time to adjust anything but it kept dying out on me after a little bit and a few seconds later would start up and run again. i am leaning towards the float being adjusted to low witch i will play around with in the next day or two i will...

i have a tors eliminator kit on the bike as well the exhaust moves a good amount of air threw threw the silencer but ill check for a nest all mounting points for the ignition is cleaned to bear metal that was the first problem when i got the quad and the reason why i replaced the whole...

Hey Guys, I have been looking for an answer to this for a little bit i have a blaster 2002 bought from a kid. i got a new top end in it fresh bore .60 over with new piston and rings. entirely new Ignition system, New coil CDI and Stator ectt.. now the kid i purchase this quad...