Recent content by pittss1c

As expected, the JJH with the clip in the #3 behaved much like the one that was in there in the #1 slot. The only unknown is weather I should buy a JJH or I think N68A is the other one I have heard of on PWK 28s

I guess that is why I am curious what others use... I know that CGL is common on Banshees

I did some searching and sifted through a lot of messages, but can not find a range of what people use. I have a vito's 240 blaster with a PWK 28 carb. The problem is that I have to put the clip all the way at the top to get it to stop burbling on it's way to the power band. (seems wrong) The...

I just had a seizure. However, I have done the same thing, but a good frame mount makes it a little better.

Looking at the piston, there isn't anything too abnormal in the areas where the discoloration is on the cylinder. The only difference is that there is standard brown coloring on the piston everywhere but the exhaust side. I just ordered a new forged piston/rings gaskets and bearing from vitos. I...

I haven't seen a listing of a big bore blaster piston by wiseco. The only option I have seen so far (I need a 73.0 mm) is from Vito's. It is $159.95 Seems a little steep.

I'll get some better pictures of the piston tonight... but I did not see any glaring defects, and my first few measurements did not appear to point to an "out of round" condition. Here is a pic of the top, all the other pics are of the intake side at the moment.

Maybe it is this one.... vito's cast piston Do I really want a cast piston, or forged? Is it OK for me to switch to a weisco?

I didn't feel any scratches. I just wanted to check if this was normal... I have not seen it before. I wanted to make sure there is no known cause outside of worn rings....

The only number are, On the top (1.0 for the size), and there is an L1 inside the piston.

Not the dark area around the circumference, the two dark patches between the exhaust port and where the rings stop. Those aren't shadows, those are actually tan spots on the cylinder wall.

I need to buy a new piston... I am not sure if I should buy an identical piston (seems to be a reasonable idea) Either way, it is a 240 (not sure which one) it is a 72mm(+1.0) piston. The truth is though, after measuring the cylinder it is actually closer to 72.9 I tried looking for pictures...

I pulled my engine apart for having low compression (I was told it was a high compression engine, but only had 110 PSI) One of the things I found was the brown/tan discoloration of the cylinder between the exhaust port and the head. I have not seen this before, any clue why this would happen?

that graph looks right... if blaster =banshee and stock = stock plus pipes+pods+reeds

Depends on who your grammer blows, if it is just your grampar it ain't so bad. If she blows you, you might be a redneck.