Recent content by OldSkoolBlaster

The Rear axle is a Banshee rear axle with a 4" extended swingarm

Blaster! duh WTF!

You can get the steering stem seals at any Yamaha Dealer.The Raptor,and YFZ 450 use the exact same seals.

400 EX is the Best bang for the buck for sure.Banshee Fronts are a good Improvement on the front for minimal cash.

I know that in order to run a 38 tooth rear sprocket on a blaster you have to grind the sprocket carrier a lil' to allow the chain to sit down on the sprocket all the way.I have heard of using a honda sprocket carrier to remedy this.I was just wondering if the bolt patterns are the same.Rocky...

Will a 38 tooth rear sprocket from a Honda TRX 450R fit my blaster?Do they have the same bolt pattern? Thanx

20 ft lbs for the head and 18 ft lbs for the jug is correct.

I am running Black Death Grips(the ones with little skulls all over) currently, they are super soft and sticky.My Buddy runs the Oury's on his Raptor and I just put a new set on his son's Blaster. Oury's Grips and are very soft,thick and sticky also.

Are Raptor and Banshee rear sprockets the same bolt pattern as a Blaster?I am wanting to order one from Rocky Mountain ATV and they don't list anything under a 40 tooth for the Blaster.I guess I could go out to my garage and compare the raptor to the blaster but I am too lazy after the long...

An LRD Pipe and silencer will run you about $400 new according to there website.I run one on my blaster and it is awesome.

Are You sure it is not a Keihin 34mm PJ or a 35mm PWK?From my experience your main jet size is lean and the pilot is rich.I just put a 35mm PWK on my Blaster and I started with a 162 main and a 55 pilot and worked down from there.I am currently running a 158 main and a 50 pilot with my mods.Just...

Howdy ya'all!I like them there Yamaha Blasters! mmmm Hhhmmm.

Banshee Front shocks are a HUGE improvement over the stock ones,as is the EX 400 rear.My total cost for a good set of banshee fronts and a rebuilt EX 400 rear is about $100.