Recent content by Matthew 570

Can you put the banshee axle in the stock blaster carrier ????.... also where do you bolt the banshee brake master cylinder on the blaster

Will the banshee axel fit in the blaster carrier and do I need a new sprocket and will the banshee axle allow for hydraulic brakes

Anyone no of a good company to get a wider rear axel at a reasonable price

Is there a kit that I can buy to switch my rear brakes to hydraulic brakes and a kit to change the front brakes to disks

Replaced the crank seals new piston and rings and a new cylinder 310 jet.....it's a whole different machine. Need to adjust the clutch a little but I'm good to go thanks for all the help

Do Do I have to split the case to replace them

Will bad crankshaft seals cause my quad to run like sh*t and have no power

I'm buying the wiesco complete engine rebuild kit top and bottom end but I need a new cylinder I'm sending back the one that I just baught where is a good place to buy just the cylinder

Does anyone know a good engine kit for a full rebuild top and bottom end

Ya it was a kit it came with the cylinder the piston and rings the connecting rod bearing and gaskets and a gasket set

I split the case everything looked good oil is in the middle of window n No Up and down play race moto parts cylinder piston and bearing no leaks except around exaust pipe at head fly wheel is tight

Finished my heat cycles and the quad is vibrating and won't go up a hill there is a loss of power and it seems like it revs real high but dosnt go anywhere I used 10w30 4 stroke oil for the case I made sure the floats were correct I have a 310 jet in the carb and the vibration has me concerned...

Just replaced my top end new piston rings and cylinder I have a dnc pipe and open air box I put a 310 jet in the carb and I'm dooing heat cycles to break in the new piston but I'm having issues the quad keeps breaking up and seems to have lost some power I can't get fuill throttle and it has a...