Recent content by Jhabeeb

hey guys I have set of raptor 350 spindles( if you wanted to convert to front hydros) I have a cylinder head machined by KOR( doubles your power output) I have a cylinder just bored with exhaust port work by KOR and also a brand new wiseco piston specifically for that cylinder I would also throw...

pm'd

I have a set of awks brakes for sale if anyone is interested

I got one if your still looking for one

pm'd thanks guys

check out my for sale post

and a pair of nice renthal bars I also have a gorgeous fmf fatty!!! you can either pm me or text me at 781 572 9682

hey guys im selling my blaster project cause I cant physically ride it ( thanks to my motorcycle). the motor has yet to be assembled and I would like to sell the motor as a whole, its to hard to part it out. the motor had they piston skirt put a hole in the case but was repaired and approved by...

hey guys so I have a set of awk brakes that have never been used, just taken out of the box and I also have some raptor 350 spindles I have never used but have been used. the raptor 350 spindles will work if you are converting to hydro brakes up front. I would like to get $150 for the awk...

yes you would have to jet it and do a plug chop

all cylinders can be port and polished I would stay away from that cylinder you posted.. I would go with OEM and either port and polish your current cylinder or find another stock one

is that axle stock length? if not im interest in it pm sent

Hey guys I have a set of cut front fenders...came with the quad when I bought but are cut very well and symmetrical I also have a rear brake setup for a quad pre 03 that allows you to run a post 03 rear caliper...comes with the whole brake assembly not to sure of the condition of the caliper...

hey guys so this brake setup was on my blaster and im just trying to figure out what it came from? my blaster predates hydraulic setup. also was wondering if it would be worth anything to sell or just scrap because I just got some awk brakes thanks

I have a sand blaster but it only fits smaller parts.. what grit should I use to sand down the frame?