Recent content by blastinfools

how do I go about advancing the timing? turning the stator? how do you judge 3*

FMF w/turbine 2

what gearing should I shoot for, 11/40 12/40 12/42...

That is kinda what I was thinkin, i'm runnin stock gearing, and I was hoping to not have to port until I'm due for another top end. Are there other power options that i've missed, what do y'all think about those reed cage spacers?

So a buddy and I went to play in the sand for the first time, last weekend, and I was a little disappointed in my blasters performance. I have a new wiseco piston stock bore, boyesen super stock carbon reads, FMF gold fatty with turbine core 2 pipe, K&N filter uncovered, just put a 280 jet in on...

Thanks guys I just found a atc250r rear on CL that I am hoping to pick up cheap,and i'll keep my eyes peeled for cheap shee's. Blasterdemon7 let me know what your tryin to part with and what your lookin to get.

Hey guys I'm getting tired of my suspention beating me to death, I've done a little searching around and I think I'm going with the ex400 rear, but the fronts have me stumped, I have no funds for elkas or works even the used ones seem a bit rich for my blood (aka my wife would kill me if I...

Hello norman420! I am new to the forum, and one of the first things I searched for was brake upgrades, because of obvious reasons, so I am curious if you sell these spindle upgrades or even if you do a whole setup with calipers, master cylinder, ect, and if so what this would run me. Thanks...