Recent content by blade88

My float level has never been changed and I have never had a problem cleaned pilot and still nothing idle comes up a little when air screw is fully seated moved the clip 1 above middle and it's running alot better but need to get the 300 main out and put in a 290 still smokes alot and running a...

My float level has never been changed and I have never had a problem

My air screw isnt changing my Idle much at all it comes up a little if I turn it all the way in and the main is a 300 my needle clip in middle and 32.5 piolt jet and runs like sh*t and heats up pretty quick and get really hot.fmf fatty pipe v-force reeds torque plate and port and polish roost...

Finally got it back running and I was told adjust air screw to fastest idle then go 1/8-1/4 turn back.right now it doesn't want to idle without choke I kinda figured it wouldnt idle.

So was I told right on setting the air screw or no???

Finally got it running doing heat cycles and break-in at 28:1 oil ratio but some how with it being ripped apart for a couple months I lost the lower left a arm but it seems to be doing ok during heat cycles but I think main jet is going to be a little rich But with the jetting I'm honestly...

forgot to metion head milled .015 for compression

im at a 32.5 pilot and 280 main now i thought vforce needed smaller jets because of the increased fuel flow

elevation of about 650-700 temp of about 70-90 f mix of 32:1 and no airbox lid

i am gettin my blaster back together.i did a slight port and polish i roughed the intake and transfer ports and polished the exhaust port there is a fmf fatty pipe kit on it vforce 4 reeds stock carb torque plate roost boost cdi.

if i put a ct racing 240 super sonic top kit and stroke it 4mm will i have to run race fuel???or can i still run pump gas?

i have a hot rod stock crank in my 88 blaster i have blown the engine 4 times now and have shattered 2 of the pistons and havent cleaned out the crank and havent had a problem yet and it was raced so i would imagine it was abused.its still strong and im getting ready to put a ct super sonic 240...

i cant find a 3mm stroker kit from hotrods anywhere amazon,ebay,or the hotrods site can someone send me a link to get one if not im gonna get a 4mm stroker

so a 3mm and a BB or no BB and the parts are being bought and the roost boost is on my blaster and has been there for over 10 years the quad was my dads for 10 years and it was there when he bought it and it had a BB on it when he bought it it was raced it had a 22 7 10 on the left front and a...

im looking to do an over haul on my engine.i want to put a BB stroker on it but i heard the 4mm blows the tranny out.so is a 3mm better or the 4mm.i dont want to break anything.also i need help with jetting BB,hot rod stroker,toomey pipe kit,roost boost cdi,26mm carb,torque plate,v4 reeds,K&N...