Recent content by 2strokesmokes

Ya that’s how I have the kick start installed but it won’t come back up once I tighten the cover down. Is there a washer or spacer I’m missing?

So the problem was that the metal ring spring was next to a disc that had a larger inside diameter so it slipped inside of it And I didn’t have the dots lined up My kickstarter doesn’t return back up and I have the springs and clips in all the right places so not sure what’s going on there

There is very small amount of peening on the rod end but I don’t know what the other rod looks like. I’ll try line the dots up Are you supposed to be able to spin the Clutch basket freely I would think with the Clutch engaged you shouldn’t be able to spin it

Does anyone know from experience what happens when you don’t line the dots up

You know what I don’t think I have the dot ligned up fml

I wonder if I can fit another clutch disc in the basket or put a second ball bearing in there Is my clutch basket worn down maybe It’s trying to grab just the push rod runs out of threads

i put a brand new tusk Clutch in and it’s doing the same thing the old Clutch did Just barely engaging The ball bearing is in there and it’s as if the push rod isn’t long enough. I have the push rod screwed pretty much as far in as it will go to get it in the adjustment mark and the 10mm nut is...

I just made a dowel pin out an 8mm dowel pin. Had to sand it down a little. Now my kick start isn’t wanting to crank over easy

I feel so stupid now. Didn’t realize you could just paste a photo there

It’s the dowel pin circled in blue

My photobucke still isn’t working but in that tinypic url it’s just above and to the right of the oil pump shaft

Every time I try to post a picture it says awaiting moderator approval

Every time I try to post a picture it says awaiting moderator approval http://i46.tinypic.com/2hxynpk.jpg

It’s the crankcase cover. After you remove all the bolts and the kick starter the pin you push out to get the cover off. I can’t find where to order it?