What Causing my piston to hit the head of my top end and digging it all up
What do you mean by digging it up?
and its getting gas on my crank
By crank, do you mean crankcase, or crankshaft?
I only can see it when I take the to end off
Where are you seeing it?
when I check the oil its the right amount
What oil are you checking?
And the carbrator is over flowing it's not going into the bowl
It must be going into the float bowl, that is where fuel goes after it has entered the carb.
that baring for the piston
Are we speaking of the wrist pin bearing, big end bearing or crankshaft bearing?
Okay one thing the piston is hitting the head of the cylinder and the guy didnt change the bearing for the piston is that why it's doing that .
To my knowledge the wrist pin bearing has no relation to piston height.
That why I rather do my own work
If you wrench as well as you explain, I do not see this motor running well soon!
And the gas isn't in the oil but on the top of the crank in it came out of the exsust what causing this
Is the cylinder flooding due to a dirty or worn needle and seat, causing hydro locking, fooling you into thinking that the piston is hitting the head?
Gee I need a stiff drink.