After reading a good bit. I was wondering what is the actual issues everyone has with Weisco Crank Shafts. If installed correctly and taken care of, whats the issue?
I live is Des Moines and know the rep and shops that deal directly with Hot Rods. The owners wife is Asian and her family owns the factory in Japan that makes them. That's how Hot Rods was started. In my hand is completely decimated Hot Rods crank pulled out of a Craigslist dead Blasty. Needle bearings shot, rod play up and down, total death. I'm sure from poor installation, air leak, but dead non the different.
Just a legit Question.
I live is Des Moines and know the rep and shops that deal directly with Hot Rods. The owners wife is Asian and her family owns the factory in Japan that makes them. That's how Hot Rods was started. In my hand is completely decimated Hot Rods crank pulled out of a Craigslist dead Blasty. Needle bearings shot, rod play up and down, total death. I'm sure from poor installation, air leak, but dead non the different.
Just a legit Question.
Last edited: