rear hydro problem

[outlawtoaster]

I have a 2000 and i switched to a banshee rear hydro, im still using the stock rotor and axle the problem is when i tried to change pads the dont fit it seems like the rotor is to thick. do i need to change the rotor and if so from what year and do i need to change the rotor hub too

i will be posting pics soon

 

[Blasterb0y794]

You shouldnt need to get a different rotor. It should be just fine. You might need to just push the piston back a little more. It sounds to me that the piston is closed a little to much for you to slide it on. Put a flat head screwdriver between the pads and seperate them, then put it back on.

 

[DUALSTROKE]

You shouldnt need to get a different rotor. It should be just fine. You might need to just push the piston back a little more. It sounds to me that the piston is closed a little to much for you to slide it on. Put a flat head screwdriver between the pads and seperate them, then put it back on.

I agree,you may want to open the cap on master cylinder before you compress it in.

 

[Braapbraap95]

Trust the man above, hes is very knowledgable man!

 

[ruthless_one3k]

I agree,you may want to open the cap on master cylinder before you compress it in.

yup just like on a car

 

[outlawtoaster]

i had the rear calipe disconnected because i needed a new hose and i still could not get the caliper compresed far enough