Idk if any of you can tell if this is ported or not, but if it is it looks like some redneck did it in his house with a dremel.
Porting?
- Thread starter nboldman
- Start date
Lol, guys i just wanted to make sure it was stock, im new to all of this. If i had the extra 200 dollars i would get it ported while its with ken but unfortunatly thats not an option.
That's not completely stock guys, the area above both intake windows has been angled and the boost port's been cleaned up....
Take a close look,closer closer... notice how the ports (even the boost port)
is way under cut and you see the sleeve. looks like someone did a small hack job and most likely screwed up the original sleeve, had it resleeved and never
cut the new sleeve down to match the ports.
I am not knocking you, I am simply stating my opinion.
Without a doubt , major performance loss the way that is setup. I have seen stock intake ports that have better flow.
is way under cut and you see the sleeve. looks like someone did a small hack job and most likely screwed up the original sleeve, had it resleeved and never
cut the new sleeve down to match the ports.
I am not knocking you, I am simply stating my opinion.
Without a doubt , major performance loss the way that is setup. I have seen stock intake ports that have better flow.
the alluminum jug that is on there has had a little port work done albeit not the prettiest but it would suffice. however whoever resleeved the cylinder never opened the ports on the sleeve to match that of the jug. it needs cleaned up big time.
You mean, Kennedy
no we dont name names here....it would be bashing and its againt the rules.....I:I
