Oil Injection system

Discussion in 'Engine' started by sgp, Dec 30, 2007.

  1. sgp

    sgp Guest

    I opened up the cover to see the oil injector and saw that someone just plugged the lines up with screws. Will that work ok without messing it up?:">
  2. randelator

    randelator New Member

    Joined:
    Nov 17, 2007
    Messages:
    877
    Likes Received:
    10
    Trophy Points:
    0
    Occupation:
    5 stars tech at yamaha motors of canada
    Location:
    quebec,canada
    well a block off kits id the best trust me cause if air come in you are screwd
  3. woodwardspecialties

    woodwardspecialties New Member

    Joined:
    Dec 12, 2007
    Messages:
    332
    Likes Received:
    2
    Trophy Points:
    18
    i would remove it and put on a blockoff kit.... its not worth the chance.
  4. Oldfart1stATV

    Oldfart1stATV New Member

    Joined:
    Oct 29, 2007
    Messages:
    539
    Likes Received:
    4
    Trophy Points:
    0
    Gender:
    Male
    Why?

    It's nothing but a worm drive pump. The shaft that goes throught to the gear is sealed. You can fill that case with water and it will do nothing but weigh a little more. Once the pump is removed it's just a little nub turning in there.

    Why do you believe they need a block off?

    True question, not flaming. I don't see any diff. between a block off plate and leaving the drive mech. in. Hell you can even take the gear off if you want.

    I don't get it????:(

    A
  5. woodwardspecialties

    woodwardspecialties New Member

    Joined:
    Dec 12, 2007
    Messages:
    332
    Likes Received:
    2
    Trophy Points:
    18
    you dont necessarily have to use a blockoff plate i guess.... thats just how i have always done it.
    just my preference.
  6. randelator

    randelator New Member

    Joined:
    Nov 17, 2007
    Messages:
    877
    Likes Received:
    10
    Trophy Points:
    0
    Occupation:
    5 stars tech at yamaha motors of canada
    Location:
    quebec,canada
    if you dont want to use a block-of kit make sure the gear thats drive the pump is remove so thats way you will be certain thats no air is suck true the engine
  7. 00blasterRESTO

    00blasterRESTO New Member

    Joined:
    Dec 4, 2007
    Messages:
    513
    Likes Received:
    3
    Trophy Points:
    0
    Occupation:
    Wrenchin
    Location:
    Corn Feilds Of Indiana
    I blew up a blaster cuz of no blockoff..........
  8. 00blasterRESTO

    00blasterRESTO New Member

    Joined:
    Dec 4, 2007
    Messages:
    513
    Likes Received:
    3
    Trophy Points:
    0
    Occupation:
    Wrenchin
    Location:
    Corn Feilds Of Indiana
    but I pulled it all the way out " pump plastic gear the whole shabang" and forgot to do anything. "many moon ago"

Share This Page