New guy needing help
- Thread starter Mikeroc283
- Start date
make sure your pick up coil is gapped correctly and is clean.
make sure your pick up on the fly wheel is good and clean.
make sure all the grounds are good
make sure you have no loose connections
make sure the wiring harness isn't cut anywhere
make sure you have the key and the on/off switch in the on position.
make sure your pick up on the fly wheel is good and clean.
make sure all the grounds are good
make sure you have no loose connections
make sure the wiring harness isn't cut anywhere
make sure you have the key and the on/off switch in the on position.
Dont know where the pickup coil is. Haven't taken the side off near the flywheel yet. All grounds are good. Wireing is loose but all wires i can take out of the connectors are in good. Harness is all good and not cut. Key is always put in the on position when i try and start it.
