so originally the problem started when my blaster backfired and shot the reeds through the carb into the intake. I cleaned everything out and installed boyeson carbon fiber reeds. when I had finished installing everything and fired the atv up, it didn't want to stay running without the throttle. I adjusted the idle on the tors (it was all disconnected just hadn't taken it off yet) and it didn't to any good. so I figured I might as well take that ugly block off the carb. so I drilled the new idle screw and installed everything using pictured instructions I found on this site. atv fired up but if I moved the atv back and forth, the idle speed would change. I didn't think much of it. I hopped on and put it in gear and it died again before I let go of the clutch. I checked the clutch cable and its not the problem. I also noticed that I still had stock jetting which I know isn't good with my mods. would jetting make this problem? and I can still never get the idle adjusted right since I took the tors off. all of the mods are in my sig