Blaster motor issue

[MaHarvey]

I recently rebuild my engine about week ago did 3 heat cycled and ran a full tank of gas without runnin it hard today I filled it up for a ride and wheelied out the drive way and it died on me tired to start it again and it was hard startinto but then idled fine but with throttle it bogs out and dies again... hoping I didn't screw the motor again still feels like good compression any ideas?

 

[bummer981]

Have you disabled the TORS?

 

[MaHarvey]

It's disconnected but still on the carb

 

[josh519]

It's disconnected but still on the carb

Follow the tors disconnect instructions, and get tors elimination kit, I had the same issue 2-weeks ago with a stock 2003, cut the wires and connected them at the carb and at the hood , runs great now

 

[MaHarvey]

Lol found the problem igniton coil wasn't grounded broke off

 

[MaHarvey]

I'm wonderin about the air fuel setting it was at half turn out when i bought it but i adjusted it and right now I'm about 2 turns out maby 1 and 3/4 some where in that area and seems like it's runnin pretty good anyone know whar the stock or usual setting is

 

[82cutty]

Start at 1.5 turns out on the pilot screw. Warm up engine for like 5-10 minutes and raise your idle . Then adjust the air screw either way to get the highest idle . Wait a few seconds to let the engine adjust . Then set the idle screw to where you want the idle

 

[MaHarvey]

Alright I'll try this tomorrow thanks