Recent content by luxuriespremier

Hey guys I am looking for a stock carburetor with or without tors removed. Thanks

Thx AWK ! Jimmer Hey buddy i did notice you ran that carb also. I am just looking for a starting point on the jetting with this carb. I live in florida so I am at sea level so i understand every location is different. Do you remember what jets and needle you used? i tried to send a message but...

Did you ever get that TM36 dialed in ?

Mokuni tm34 carb it needs to be tilted slightly with the stock air boot. I'm ordering a aftermarket but I wanted to break this new engine in

Hey guys I needsome quick info on crabs. I have my carb turned 15 degrees to the left from straight up . Will this affect anything as far running or performance ?

My Buddy just replaced his clutch and now he says when He puts it in first gear the bike just dies. It runs in neutral and if you put it in first or second it dies and moves a little bit he even tried reving it a bit. What could be the problem? The clutch soaked in oil overnight before install...

Thanks for the info i am going to dig into it and see if I can find something out of place. Do the ball joints ever get bent or go bad at the A-arms ?

Hey guys I flipped my blaster the other day and thought nothing of it. I rode for the remainder of the day and when I got home I found the front right tire bent inwards. If I look straight at the bike the top of the tire is leaning into the bike almost like a toe\ camber adjustment but these...

I push on the ouuter part of the bearing. I will definately be removing that seal and packing them . Thanks

hhmm ok I can see the possiblity of tolerance but I dont see how the bearings would prematurly fail. They hadt obe pressed in and the axle went on tight also "No play". The One on the drive chain side seems to fail first and my chain is set to factory spec. I think I am going to add a zerk and...

Hey what do you guys run for bearings? I replaced mine 6 months ago and there already starting to wear out. I also wa wondering if anyone Reyes tapping a zero onto the reAr carrier so I can keep grease in and dirt out. Thanks

thanks man is it just the cable or full setup ?

Hey guys I had a couple questions regarding carb and intake. I just bought a 34mm mikuni carb I was wondering if i can use the blaster throttle cable also is there a kit sold to attach these carbs to the stock air box? thanks

Has anyone heard of a arm extenders ? Where do I get them ? Pros and cons? And no I don't mean wheel spacers

Thanks for the support guys ! I actually can't wait to hop on it again lol. If ken lets me of course haha