Recent content by Dic

yay !!!!! cleaned all electrical contacts to spark plug, coil etc etc, and did the washer in the carb success, goes like stink now still won't idle, so adjusted the cable (naughty I know) need to tidy a few things up, but essentially there did decide not to start for 5 minutes. really odd...

Awesome. Fabricate one in the morning. Thanks speedy slyder

OK Going to take 2 weeks or so to get it. Can anyone tell me how thick it is and I'll fabricate one. Wanna ride......

Going to check all ground points and everything associated with spark. Have already cleaned and prefixed plug cap Tank breather is clear Now, the washer under the main jet. Is that basically securing the main jet body ( brass bit needle slides in) so it doesn't move up with the needle. If so...

No just silencer All back together. Float level correct. Not leaking any more and checked using tip with clear tube Put air filter back on and went for spin 3 km or so. Still no better. Bit confused as to problems now Won't idle. Flat at the top and sometimes runs great for a few seconds then...

That's very true but it is only the silencer that's been changed. Not the main expansion chamber so don't think thatsctoo much of an issue........or could it be

an exhaust ? no markings but deffo not original

nahhh, got the mice out the exhaust. showed it to a cat, but it is clear it's not stock exhaust, but it has been chopped to fit, but have standard one too plug boot is fine being in a barn and in a hot country it's not so bad

thanks for advice Merc. was only to test a theory but good advice non the less Blaaster, when the line is attatched to the drain nipple, what sort of height on the outside of the carb should it be level with the carb has been stripped, cleaned, new seals gaskets, jets etc etc from a standard...

yep, need to test my tester first...........thats the homemade one using table leg rubbers works a treat tho anyway leak test done, industion leak, now fixed. 7 psi for 30 minutes. no drop off running alot better but still rough and no idle took for run, came back, damp and black spark plug...

ok, so homemade tester it is.......... the breather from the transmission. this would obviously be clamped prior to testing correct ? thanks all

ok, so all new seals etc from moose kit, floats set etc etc can't leak test yet as no kit, but maybe soon now it runs tors removed parking brake sensor removed runs, but won't idle despite major fiddling also when running it doesn't really have any guts at top end. just pops and splutters but...

HI all Silly questionj I know What grade etc of oil should I be using in the engine not the 2 stroke stuff, but engine oil Thanks Dic

thank you very useful

thank you Blaaster much appreciated o rings are all shrunk and dry as well so thats not helping cheers