Recent content by cap9709

Still have plastics or any other parts for sale? Pm back thanks

Still have breaks? Also I am In search of fro t fenders

Otherthan fmf that's pretty much it

Would you recommend going back to stock? And definitely not an 03 then, no discs up front.

Whoops read your question wrong lol AEM meaning aftermarket. It was a name brand I'm just drawing a blank and not with the bike at the moment.

Could the filter not work? Or probably just needs a good cleaning. I believe 03 I need to run the vin

The current air filter is not stock its some AEM one that attaches straight to the carby and is only about 4" long by 2" diameter

Trying to find a decent cheap set of yellow front plastics. Send me a PM if you have some. Also looking for an AEM front bumper. Thanks!

Carb clean, air screw 1.5 turns, height 21mm, compression no idea, air filter could be dirty. Yes tested and fixed the leaks

Finally today fixed the gas leak and little air leaks and she runs like a champ but idle is a little wacky. It smokes a decent amount not terrible but I'm kind of new to 2 strokes it could be totally fine but not sure. At idle it is ok for the first 20 seconds then will slowly idle down and die...

Got a pic of a crank seal? Sorry I'm kind of a newbie

It leaked nearly as soon as I put in air with just a little hand pump. Held best around 3 psi but for only less than 10 seconds. I checked tester like 4 times and stil haven't found the dang thing

Hey guys just did an air leak test and found one leak at the intake. Put on a new gasket and fixed that one. Still have another though that I can'tfind. II've covered the whole engine in soapy water and its not bubbling anywhere. Where could this leak be? Thanks!

Yes sir all I did was clean it I did not adjust float as I'm not totally sure the stock specs and also the air mixture screw? Currently 1.5 turns out