so i bought a blaster spacer and opened it up to fot but in retrospect i think i will next time get a cr reed spacer or just make it from scratch for a few dollars. if i knew how to weld aluminum i would just weld a cr spacer on to the jug!!
so i bought a blaster spacer and opened it up to fot but in retrospect i think i will next time get a cr reed spacer or just make it from scratch for a few dollars. if i knew how to weld aluminum i would just weld a cr spacer on to the jug!!
heres a profile shot demonstrating how much deeper these cr reeds are!!
it's still in the rough but everthing fits!!!! yes the walls are hella thin now but they'll hold.
they sure look good in there
i shave around 1-1.5mm off each side with a flat file and sand paper tape
sweet they finally fit!!!!!!!
this is an the gasket off my 90 cr125 reeds ,its amazing how well the bolt holes line up!
N8tsNastyBlasty

so i bought a blaster spacer and opened it up to fot but in retrospect i think i will next time get a cr reed spacer or just make it from scratch for a few dollars. if i knew how to weld aluminum i would just weld a cr spacer on to the jug!!

1995blaster
you can weld it to the jug with some rods from harbor freight and some mapp gas. ask sicivicsdude he uses it on cases
 

Media information

Album
cr125 reeds!!
Added by
N8tsNastyBlasty
Date added
View count
1,028
Comment count
1
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
4780-1296808358-13f0751f9557d241a407304a7654a52a.jpg
File size
42.1 KB
Dimensions
600px x 450px

Share this media

Top Bottom
Back