it's still in the rough but everthing fits!!!! yes the walls are hella thin now but they'll hold.
so i bought a blaster spacer and opened it up to fot but in retrospect i think i will next time get a cr reed spacer or just make it from scratch for a few dollars. if i knew how to weld aluminum i would just weld a cr spacer on to the jug!!
heres a profile shot demonstrating how much deeper these cr reeds are!!
it's still in the rough but everthing fits!!!! yes the walls are hella thin now but they'll hold.
they sure look good in there
i shave around 1-1.5mm off each side with a flat file and sand paper tape
sweet they finally fit!!!!!!!
this is an the gasket off my 90 cr125 reeds ,its amazing how well the bolt holes line up!
N8tsNastyBlasty

it's still in the rough but everthing fits!!!! yes the walls are hella thin now but they'll hold.

There are no comments to display.

Media information

Album
cr125 reeds!!
Added by
N8tsNastyBlasty
Date added
View count
934
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
4778-1296808358-f43ea0ce946bf2590066aae46eacd61b.jpg
File size
33.4 KB
Dimensions
600px x 450px

Share this media

Top Bottom
Back