What jet size for fmf pipe and reeds?

[Jshomphe]

I have an 01 blaster, I just rebuild the top end with a complete wiesco 200 kit. I was wondering what size jets would be best for this scenario. I have a full fmf exhaust and vforce 4 reeds, also a few holes drilled in the air box cover. Elevation 0 - 500 ft.
Thanks in advance for any suggestions!!

 

[Awk08]

I'd buy 270 thru 310 mains, start large and plug chop down
https://www.blasterforum.com/threads/how-to-plug-chop.53237/

 

[STurnerXM2010]

I think Awk is dead on. I started with a similar set up and ended up at a 290 main. I would also suggest taking the jet selection beyond the main. Alot of guys want to focus on the main jet when the slightest adjustment to your air mixture screw, pilot or needle jet will completely alter the main selection. Try to go by the book and start at the bottom. It'll prove to save ya alot of time and frustration. Nothing worse than settling on a main jet only to find out she falls on her nose through the mid section or out of a corner!