No spark whatsoever

[motoman159]

So ive got no spark at all, not even the faintest spark, i can even touch the electrode and kick it as hard as i can and it doesnt even shock. the thing is it sparked well before being taken apart. all my wiring is correct and intact. what could cause no spark from just sitting for a few months disassembled.

 

[Quadman1]

Are the grounds clear? Stator wires hooked up right? Is the flywheel clean?

 

[MercMenace]

Coil tested? If you took it all apart I would look at the stator and grounds as mentioned above.

 

[motoman159]

Are the grounds clear? Stator wires hooked up right? Is the flywheel clean?

yes yes and yes

 

[Larry's Shee]

Unplug kill and jump ignition switch. Check taht ALL connections are clean and tite. Check that a mouse didn't chew a wire.

 

[MercMenace]

you could also unscrew the Spark Plug boot from the coil wire. cut about a 1/4 inch from the coil wire and rescrew on the boot.

 

[motoman159]

Unplug kill and jump ignition switch. Check taht ALL connections are clean and tite. Check that a mouse didn't chew a wire.

you could also unscrew the Spark Plug boot from the coil wire. cut about a 1/4 inch from the coil wire and rescrew on the boot.

tried both of these already.

 

[MercMenace]

I guess recheck your grounds. Grab an ohm meter and start checking.

Here is the manual that gives all the testing procedures.

http://www.blasterforum.com/threads/downloadable-yamaha-blaster-manual.17325/

 

[MercMenace]

New sparkplug?

 

[Quadman1]

Get a meter like said and test all your connections. Also test coil and stator wires.

 

[motoman159]

Get a meter like said and test all your connections. Also test coil and stator wires.

OK found the problem I get power to the coil wire but no power to the end of the boot. It's an aftermarket coil to so that sucks it's broken.

 

[MercMenace]

Glad you found it. coils are easy to come by.

BTW Jealous of your dad's setup out there.

 

[Quadman1]

You can get a new boot... Try to shave a little off of it.