A-arm bushing removal?

[metron]

Whats the easiest way to remove & replace the plastic bushings on the front a-arms?

 

[Herpderplol]

take off the a-arms and pull them out

 

[metron]

I took the arms off but the bushings are dried out and dont wanna budge

 

[dirtysquared]

Take a hack saw blade and cut a line through the bushing. It takes awhile, but once its through take a pair of channellocks and squeeze the outside of the bushing and turn. It should pop right out then.

I just did that to some arms about an hour ago, and everyone came right out.

Fred

 

[Fast6hand]

I used a long piece of rod with a blunt edge and drove them out from the opposite side with a hammer. Not to blunt so not to damage the inside of the shaft. I bet a blind bearing puller would work well also.