Search results

Alright so there are probably going to be a lot of photos, so sorry in advance. BUT... On a positive note when thoroughly going over the carb while I had it apart today, I found that while the pilot jet(removable) was clean and clear, the actual hole it leads to in the carb was completely...

thanks guys, I'll pick up some of the hi temp copper RTV gasket stuff tomorrow to seal that up. As far as mods the only one done to it is the TORS removal. The pilot jet is 32.5 and I replaced it as one of my first steps. It did get a little more gunk in it before I realized the air filter...

hey gentlemen, sorry I've been MIA but work and life has been crazy and I finally got a whack and testing out the leak down tester this evening. It did drop a little but not as significantly as I expected. It dropped from about 7 to 6 over about 10 minutes. I sprayed the soapy water around...

Message sent awk thanks. Speedy, the air mixture screw is set 1.5 turns out and the slide seems to be operating freely without sticking except when I had the throttle cable almost out to the last thread, that's when it was running away

where is a link to buy one of your testers? looks like you've got a pretty good setup and other on the forums pointed me to do a leakdown test. Sorry was going to send you a message, but couldn't figure out how from my phone :). Thanks

Thanks so much for the quick response guys. I'll check out the leak down test section and report back in a few days when I'm able to work on it again. A month ago I couldn't have pointed to the carb, these forums have some awesome info ;)

Also others than the Tors mod it is completely stock as far as I can tell. Still injected, etc

Hey everyone, I'll start off by saying I'm not extremely mechanical so be gentle with any explanations :). My blaster is an '05 and we got it used about a year ago. It had been parked for a while and didn't run at all when we got it, but my father in law worked on the carb and got it running and...